Magnum-venus-plastech UltraMAX HVLS-1000 Series User Manual download pdf (Page 18)

HVLS-1000 Series Fluid Section Manual

Rev. 05/2012 Page | 18

NOTE: Lubriplate® is a registered trademark of the Lubriplate division of Fiske Brothers

Refining Company.

NOTE: Loctite™ is a trademark of the Loctite Corporation.

NOTE: Teflon® is a registered trademark of E.I. DuPont de Nemours and Co.

IMPORTANT WARRANTY INFORMATION

Please note that components used on this equipment are made of specially developed, high-

strength material.



Only authentic Magnum Venus Plastech replacement parts are acceptable for

use with this equipment.



Use of unacceptable replacement parts will void our liability and warranty of this

equipment.

Please contact your Magnum Venus Plastech distributor for more information.

Installation & Set-up:

1. Check all clamp brackets, pump column, slave arm bracket, manifold clamp, etc. to make

sure they will not move when unit is in operation.

2. Check the mounting of catalyst pump to make sure clevis pins are secure.

3. Make sure exhaust silencer is secured to the power cylinder of the resin pump.

IMPORTANT: Snug up the packing nut at the top of the catalyst pump approximately ¼

turn.

4. Snug up, tighten, the resin pump packing by inserting two rods into the holes in the oil cup

at the top of the resin pump fluid section. Turn clockwise until packing is snug. Note: Do

not over tighten.

5. Pro Gun: Tighten the gun valve rod packing nuts until they are very snug. IMPORTANT:

Activate the gun trigger 10 - 15 times then tighten the packing nuts. Repeat this

tightening procedure 3 times to make sure the gun valve rod packing is tight.

6. Attach Suction Wand to Resin Pump.

a. Check all fittings on the wand assembly to make sure they are airtight.

b. Attach the wand assembly to the foot valve port of the resin pump.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

No comments

Magnum-venus-plastech UltraMAX HVLS-1000 Series User Manual Page 18