Magnum-venus-plastech PATRIOT 10 PAT-PH-10000 User Manual download pdf (Page 20)

Patriot Powerhead Manual PAT-PH-10000

Rev. 10/2012 Page | 20

Air Cylinder Disassembly:

NOTE: Have a current drawing for the Powerhead you are working on to reference

for part numbers.

1. Remove the Sleeve Clip (PAT-PA-9112) from the Lower Rod (PAT-PH-10009).

Lift the Shell Retainer (PAT-PA-9110) up and remove the two Half Shells (VPH-

10009).

NOTE: The air motor can be removed from the unit for repair or the following

procedures can be performed while the motor is mounted in place

2. Remove the five upper Hex Nuts (F-HN-06F) from the Tie Rods (PAT-PH-5006).

Pull the Upper End Cap (PAT-PH-10012) off the Cylinder (PAT-PH-10003) and

Upper Shaft (PAT-PH-10008).

3. Slide Cylinder (PAT-PH-10003) off of Piston (VPH-10006)

4. Slide the Piston assembly (VPH-10006) up from the Lower End Cap.

5. Remove Snap Ring (7205-2-26) from the Upper Busing using the snap ring

pliers.

6. Push the Upper Bushing out of the Upper End Cap.

7. Remove Snap Ring from the Lower Bushing.

8. Push the Lower Bushing out of the Lower End Cap.

9. Replace all O-rings and coat with brown grease (08465). Coat the inside of the

cylinder, piston rods and piston rod bushing with brown grease (08465).

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 33 34

No comments

Magnum-venus-plastech PATRIOT 10 PAT-PH-10000 User Manual Page 20