Magnum-venus-plastech PATRIOT 10 PAT-PH-10000 User Manual download pdf (Page 23)

Patriot Powerhead Manual PAT-PH-10000

Rev. 10/2012 Page | 23

Air Cylinder Assembly:

NOTE: Have a current drawing for the Powerhead you are working on to reference

for part numbers.

1. Apply a thin coat of brown grease to the inner bore of the Lower End Cap (PAT-

PH-10004) and install the Lower Bushing (VPH-7005).

2. Install snap ring to secure the Lower Bushing in place.

3. Apply a thin coat of brown grease to the inner bore of the Upper End Cap (PAT-

PH-10012) and install the Upper Bushing.

4. Install Snap Ring (7205-2-26) to secure the Upper Bushing in place.

5. Insert the Lower Rod through the Piston Rod Bushing of the Lower End Cap.

6. Slide the Cylinder (PAT-PH-10003) over the Piston (VPH-10006) down onto the

Lower End Cap O-ring (O-B-167).

NOTE: Use caution not to damage the O-ring in the Upper Bushing when

installing the Upper End Cap over the Upper Rod.

7. Set the Upper End Cap (PAT-PH-10012) onto the Cylinder with the valve block

flats facing the same direction. Screw the Hex Nuts (F-HN-06F) onto the Tie

Rods and snug the Hex Nuts. See bolt torque procedures section of this

manual for details.

8. Lift the Shell Retainer (PAT-PA-9110) up and Install the two Half Shells (VPH-

10009) to the end of both rod buttons. Install Sleeve Clip (PAT-PH-9112) to the

Lower Rod (PAT-PH-10009).

9. Connect the pilot air hose and regulated air hose to air motor.

10. Install the Muffler using the two Hex Head Cap Screws (F-HB-04C-56-SS).

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 33 34

No comments

Magnum-venus-plastech PATRIOT 10 PAT-PH-10000 User Manual Page 23